connecting BI 4.0 to Legacy WatchNet NVR

Although you can find a list of tested and supported cameras at blueirissoftware.com/Technology, this is a good spot to share or inquire about what cameras have been most successful with Blue Iris for you with other users.
Post Reply
Maurice
Posts: 1
Joined: Sat May 26, 2018 2:50 am

connecting BI 4.0 to Legacy WatchNet NVR

Post by Maurice » Sat May 26, 2018 3:17 am

I am trying to connect a WatchNet NVR to Blue Iris to get some legacy cameras brought into it. When I perform the inspect in BI, it calls up a generic Camera. I spoke to WatchNet and they said that their NVR supports RTSP on 554 and the command line was as follows

rtsp://admin:pass@192.168.10.3:554/cam/realmonitor?channel=1&subtype=1
The camera supports both TCP and UDP transmission forms.

Attached is a screen shot when I run the inspect

I also get No Signal - RTSP 404 not found on the screen
The NVR is an WatchNet E-240008RTSH

Any help is appreciated

Post Reply